Post-firing Firing post...

It has been a few days since my last post so this one is going to be a long one...all about the salt firing I just finished monday morning at 3 a.m.! This was the 6th time I've fired the kiln here in Brush Valley and the 3rd time for mostly rawglazed pots. For some of you who aren't potters, this means that I glaze the work when it is leather hard, using slip glazes that have a large amount of clay in the batch recipes. The clay in the glaze allows the glaze to shrink with the pot as water evaporates during the drying process. It can be tricky and most people choose to bisque fire their work and then glaze, but out of necessity, with no electric/bisque kiln here in Brush Valley, and the fact that most of my work only needs a liner glaze, I use this process of once firing. Once the pots are dry, it's time to load and fire.

Mugs tumblers, soup bowls and plates, lidded jars

and pitchers.

The firebox extension worked out great

for preheating the greenware/rawglazed pots.

I loaded it up with large cherry and oak chunks,

clammed it up and went to bed around

4am. At 8 am I returned to find

coals still in the box and started the firing...

Without a Pyrometer to gauge the early

part of the drying process

I used this chimney

thermometer for a wood stove.

I need it for the beginning of the firing

to make sure nothng blows up at the point

where the water left in the pots

starts to "boil" or evaporate...

Toward the end of the firing we used the flame

to stoke off of and had a nice,

even firing of cone ten down.

Heres a picture of the kiln shed and flame coming

from the chimney. As soon as the flame went in, I

stoked again, and the flame lasted abut 1 1/2 minutes per

stoke. This temperature(nearly 2400 degrees) really ate up the wood!

I hope to post pics of the finished results soon! Dont forget about the potters tour! Can't wait to see you all here!